Ha ha have you been drinking, mine is like most L200 ac units it don't work lmao

Quote: Major Malfunction wrote in post #1224

---

Mine is fitted when you press the button the windows wind down lol

---

nice log trailer

Would be interested in a how to for the onboard air system chef! I was thinking of doing this to mine!

i can do that when I am finished, I need a ac pump bracket though

got the 2nd battery fitted today and the air reciever

What's the second batt for and where have you fitted it @123hotchef

second battery is in the tub it was going under the tub but thought better of it! second battery will be for work lights ect and if i get a flat main battery i can flip the switch and start off of it too

Are you putting the winch direct to the main batt

yes mate too much cable run other wise if I fit a rear winch i would use the rear battery

Ordering mine next week got to get it delivered back in L/pool so can't get it fitted for a few weeks doh.
Think I may need new batt as mine is starting to cook a bit. It must be about 6/7 years old

i aint ordered my winch yet

Go on ya know you want it lol

i will get that ordered too

Quote: 123hotchef wrote in post #1237

---

i aint ordered my winch yet

---

Hey @123hotchef - finally got round to (attempting to fit) those belly plates - wondering what modifications you made to them? cos the rear one doesn't fit so well at the back. I guess it's supposed to attach on the gearbox cross-member bolts? Also looks like it's going to interfere with the torsion bars. Not sure if there's meant to be another bracket or something that I don't have on mine.... If you've got the time a pic would be good.

Still not fitted mine, it needs chopping to fit and holes drilled to match @Heathen

That's what I thought - holes at back are too small and it looks like it's going to interfere with the torsion bars too.

i did fit it as is it needs spacing and longer bolts in the x member

mine has now been chopped and re drilled and i welded in another bit of box ection drilled and tapped it to bolt the plate too i will take some pics tomorrow for you mate,

and no it did not interfeer with the T bars

Saturday I ran all the pipe work and mounted the oil separator for the on board air, painted the battery and air boxes in the tub, just waiting on the compressor and bits to be sent.

Second battery and intelligent split charge system is all up and running

the air system has been pressurized by my garage compressor to 150 bar only leak was a cheap fake QR pcl fitting now been binned and a real one obtained

compressor all bolted up belt on tension set, just filled up a 25L tank to 150psi in 30 seconds at idle which aint bad would be quicker at higher revs i need to re connect the hand throttle then I can use a windy gun on the lug nuts no bother! probably could now but I like to be sure!

just ordered some louder bigger air horns now I have real air.

Quote: 123hotchef wrote in post #1247

---

just ordered some louder bigger air horns now I have real air.

---

ha ha ha i didnt think bout it for like a second

I make that 16CFM - pretty nice