Has anyone disassembled an ABS pump?

This is on a 2005 and it's not obvious how to remove the ECU and solenoid body from the valve body. I can take the lid off the ECU and I see some clear goop. I can remove the motor if I wanted to replace the motor or brushes but that part works fine.

Most ABS pumps have external bolts/screws where the ECU and solenoid body can be easily removed as an assembly.

Under the cover there are 2 little screws holding the PCB but the PCB is firmly in place and I'm reluctant to apply too much force to remove the PCB, assuming it is intended be removed. There are wire bonds that make me believe that while a repair may be possible this was never intended. These wire bonds would need replacing with wire and solder so not a small job.

Any insight would be appreciated.

Bild entfernt (keine Rechte)