Hi all, I have a 2003 2.5 k74 4d56 warrior, it was a fbw, but came without an engine...I have a decent pre fbw engine etc with a rotten body and want to put that engine in. I've been searching for a guide on here but can't find one...can anyone point me in the right direction?
Thanks, Danny.

@Alan G you had the pre fbw engine in yours didn’t you and I’m sure someone on here has done this conversion and there’s a thread about it floating around in the ether of the forum.
@Kwakninja are you the guy who’s Ben asking on one of the l200 groups and chatting to a guy called Sam ?

Yes that's right, although they have been less than helpful...apart from Sam...I've tried looking for the thread but had no joy. It's re locating all the breather pipes and which plug to use on the pump I'm struggling with.

Quote: Kwakninja wrote in post #3

---

Yes that's right, although they have been less than helpful...apart from Sam...I've tried looking for the thread but had no joy. It's re locating all the breather pipes and which plug to use on the pump I'm struggling with.

---

Haha, that's the best way to do it mate! I followed your fb advice and got loads if pictures soni know what goes where to a certain degree, it's just knowing which pipes from fbw need plumbed in if that makes sense.

Hopefully Alan will reply soon as he is very knowledgeable about them and should be able to point you in the direction for the last bit, I’m going to assume you live way up country from Kent or to the west ?

Quote: Kwakninja wrote in post #1

---

Hi all, I have a 2003 2.5 k74 4d56 warrior, it was a fbw, but came without an engine...I have a decent pre fbw engine etc with a rotten body and want to put that engine in. I've been searching for a guide on here but can't find one...can anyone point me in the right direction?
Thanks, Danny.

---

@Alan G sorry to drag you into this but as resident guru you were the first person that came to mind , I invited @Kwakninja to join the Group as one of the other l200 Facebook groups wasn’t to helpful and I was struggling as I have the fbw engine and can’t remember who did the same swap on here 🙂

No probs mate.

There are a couple of ways to do it so easier to speak to Danny.

Brilliant, thank you both so much for this! I'll give you a call tonight.

Yes...I'm in Scotland...always the way haha!

Quote: Kwakninja wrote in post #10

---

Brilliant, thank you both so much for this! I'll give you a call tonight.

Yes...I'm in Scotland...always the way haha!

---

Just outside Perth, PH13...can I give you a bell tomorrow mate as my phone's got rubbish signal tonight with the storm!

Yep thats fine bud.

Call me tomorrow afternoon. If I dont answer I will call you back.

@Kwakninja : did you have any succes? I'm planning to do more or less the same swap. I'm sure I can figure everything out, but help is always welcome